If your home has suffered a water leak unlucky, learn how to repair water damage on a plan will help you save hundreds of dollars in repair costs and finishing. Because water damage affects all types of floor tiles, wood and laminate flooring,repair by a licensed commercial contractor is essential to your success.
How to repair water damage on a floor – Vinyl Tiles
Solutions linoleum tile or vinyl floors are some of the available and less expensive because they are among the simplest types of plants to clean and maintain, which are commonly found in bathrooms and kitchens. However, it is used in wet environments like these also increases the risk of tiles affected by water damage, especially if the water is not absorbed immediately.
One of the advantages of linoleum and vinyl tile is the possibility of replacing the tile or tiles that are damaged; you not have to break the whole floor.
Start by checking the damaged with a knife or a vinyl tile cutter tile. Use a scraper to start one side of the tile and start tapping. In case of broken tiles, do not worry. Once you get the tiles to be rescued, scrape all the old glue off the floor and clean all the dirt. Wash the floor down with warm soapy water and a clean sponge. Let the soil test completely and recheck for adhesive or debris.
Depending on the type of tile (self-adhesive or glue down) have, as shown installation. Use a roller to ensure good adhesion tile makes with the ground. If you are installing a tile with glue, clean the edges of the tile, wiping away any adhesive that came through the seams.
How to repair water damage on a wooden floor
Water plants and wood do not mix. Over time, water can produce white or black unsightly stains on the floor. Here it is how to fix the water damage on a floor laid with real wood planks.
Use masking tape to delineate the affected area. Remove the top layer of wax with steel wool, then move to a sandpaper 80 or 60 grit to remove surface finish, gradually changing grits to 100 grit paper Sanding wood all the way to the edges of the tape and clean the debris when finished.
Take a cup of hot water, add oxalic acid crystals (available at your local hardware store) and stir until the crystals dissolve. Continue adding crystals until melted more. Apply the solution on the affected area and let dry. Once dry, clean the windows and apply another layer of the solution. Continue this process until the stain is completely gone. Follow the instructions and safety information on the bottle of oxalic acid crystals. Wear gloves and eye protection when using this product.
And seal the affected spots so that matches the color of the surrounding pavement area.
Repairing a laminate floor arched
Laminate flooring is full of demands that is waterproof, but do not be fooled; if the water sits on the floor enough, it will buckle. The biggest problem with repairing plank flooring is always out. The panels are locked together by a male and female mode; to replace the area that is the deformation, the soil should be removed from the nearest wall to the affected area.
Remove quarter line round the perimeter of the nearest wall floor buckle. With a small lever will help make this process easier. Since laminate floors are “floating” which is not installed flush with the wall; must be a small space between the dashboard and the wall. Pull up the affected tables and remove any water damaged card area. Absolutely sure that no residual water in the soil or under the foam sheet. If there is water, put a dehumidifier near the area and let it dry completely before placing the replacement joints.
Install replacement boards and return the original, boards do not hit their places in the installation sequence. Reinstall the adjustment for the neighborhood and the work has been completed.